Search Results for ‘parts’

Hello, I'm looking for the following drive shafts. Feel free to message me with what you have. Toyota 4 runner drive shaft with drive flanges (front or rear). Chevy NP241 rear drive shaft with slip yoke.

Hey Everyone, this is my first post on a forum and Im not sure where to post it but ill do it here I guess. Anyways im a fairly new Jeep owner (since July) and I have a 2 door 2014 Wrangler Rubicon X fully loaded and i dont really know who in the area around vancouver island is the best to deal...

...frame is good, and Very high KM diesel still strong, no smoke etc, as well as running gear. Just the body is horrible now. How hard is it to replace the body? That said....what would the big parts be worth on a parting out basis? manual Trans. any words words welcome. I'm in Prince George...

Here is the link to my FB page pics and all https://www.facebook.com/groups/289352467891419/permalink/450204338472897/

I have purchased myself a 1995 Pathfinder and it well needless to say needs some body work done on her. Anyone know where I can find in the Greater Vancouver area replacement Panels, Bumpers, Interior Door Panels, and Fender? I'm new to this community and I am just testing the waters. Also if...

lower control arms 50 for fixed 75 for adjustable upper control arm new bushings 150 bucks new in box pass side tj mirror 97-06 90 bucks new in box rear tow hook 20 bucks rear tube bumper 150bucks stock suspention parts from a 06 6 banger tj obo 2.5 inch lift kit for a 4 banger 350 bucks full...

1976 Chevy K5 Blazer for sale. Small block 400 with a t350. The motor has seen better days. No battery, currently doesn't start. I hacked an electric fuel pump onto it so I could drive it down from the Okanagan. It's got so many problems, I'm never really going to get around to building it...

selling my old 91 4runner it was flopped on drivers side. selling whole for 600obo or will yank parts that are wanted this weekend. the 4runner has a 4 inch lift in it good running 3vze with auto trans/tcase. i have no way to pull these pieces so they will goto scrap with the body unless...

So far, I've got the bellhousing and the Line from master to slave. I still need the fork, external bearing retainer (long snout), throwout bearing, clutch release piviot (little ball on a bolt), and the clutch release spring. If you have anything let me know. Thanks guys!