Hey Guys, :help:
I noticed gear oil leaking from my front left axle today onto the tire.
I can't tell if its coming from the joint or from where! Enough to cause a small rivlet in my garage and the inside of my wheel well to be sprayed in oil.
Damn, any ideas what is leaking in there, or...
I bought a triple gauge set for the Jimny,
She's got the G13BA motor.
Can't find a bung for the oil pressure sensor anywhere on the motor!
Has anyone installed an oil press gauge on there sammy
Has anyone found one?!!
just got me a RHD Jimny Sierra. FOTB. Haven't even got 'er inspected yet! Got do a clutch on it though right away. Should I go centerforce?? Anyone else have one?
I'd like to go with a 2-3" lift as well, any suggestions?
Just got a 1987 Suzuki Samurai JX (long wheel base). It is almost entirely stock. Hope to find some friends here to help me get my Samurai looking and driving better. My 1st plan is to try to find a lift kit and larger tires. I don't want to make a rock crawler with it just a decent 4x4...
So its getting to the point where I want to get lockers for my Samurai. I'm running 31's currently and have a sidekick transfer case that I will be mating to my samurai case with 4.16 gears. I would like to get ARB's as I still drive the truck on the road in the summer and sometimes in the...
Mods can delete thread if they'd like!!!
Thanks to everyone who enquired!
Okay so, Sammi the Samurai has sustained some damage since I posted this. She will need the windshield replaced, and the clutch pedal(just a piece of it is broken, where...
I am about to get some t-case gears for my 87 Samurai and I am debating whether or not to change to a twin stick or Twisted TT shifter by Trail Tough while my T-case is apart.
But what I am...
1986 suzuki samurai LWB
1991 1.6 8 valve fuel injected motor
New samurai rad
In tank sidekick fuel pump (works but leaks a little around the flange, comes with spare pump
Thorley header and new 2” exhaust all the way to the back
Sidekick power steering pump and box on petroworks wedge box...
This truck is in Gold Bridge, BC, but i can change the tps and drive it down, hoping that somebody might want it as is where is so i don't have to deal with it.
It's a 91, so EFI, excellent compression
ECU serviced, all caps replaced and re-sealed
SPOA + Shackle lift (at least 6")...
I am looking for a samurai, there a pain in the ass to find. I would like an 1980-90, Convertible, and it has to be standard (Although I don't think they even came in auto). It would be nice if the engine ran, doesn't mater if there is body damage (just solid body mounts). Also don't want to pay...
So I am building a dual transfer case setup for my samurai and I am in need of a front output slip yoke ( I think that's what it is called) from an 89-94 sidekick or tracker for the splined coupler between the two cases. All I need is the splined output end off the front driveshaft.
When I first bought my samurai I thought the ride was rough with the stock leaf springs...then I lifted it with the TG 3" leafs and the ride got even worse. The common problem with the samurai is that the front springs are too short and have a way too stiff spring rate.
So to fix the problem I...
I bought some new wheels for my SJ410 and the stock wheel nuts that I have are not large enough to properly hold on the wheels.
I went to Kal-Tire and Lordco and neither of them were able to help - but they didn't really try.
If anyone could reccomend what type and where I should go to get...
Well its time for new tires for my Samurai.
What do you guys run and on what rims?
Currently I am running 30x9.5x15 BFG mud terrains on the stock 15x5.5 rims. My intentions are to get some 31x10.5x15 Interco Trxus MT's, but will they fit on my 5.5 wide rims?
I have about 3" of lift (spring...
Anyone know where I could buy a set of 4 back spaced rims? I am looking for about a 2.5" back spacing with a 5x5.5 bolt pattern for my samurai. Are there any stores in the lower mainland that offer these wheels for a decent price or are they an item to be ordered?
Any suggestions would be great.
So I am looking for a set of shocks for my samurai. I will be installing a coil suspension soon and I want a shock that has decent travel and a good ride. I currently have Skyjacker Hydro 7000's but they seem pretty stiff, mind you that's probably because of my leafs.
I read the BC4x4 Doetsch...
I am designing and building a cross over steering setup for my 4th yr engineering project, so I am in need of a drag link and passenger side knuckle with caliper bracket for a samurai.
I will be mounting a strain gauge to my drag link and measuring the strain from steering while driving. In...