BC 4x4 Forums banner
1 - 1 of 1 Posts

16 Posts
Discussion Starter · #1 ·
I have a pair of 1978 ford three ton 4x4 axles, with a 7:20 to 1 ratio.
They need some work, such as, brakes, tie rod ends, and one stub shaft on the front axle is broken.
I have had the diffs apart and they are nice and clean with no wear present on the gears.
The units have a six stud bolt pattern that fits most 20" wheels.
I understand that they are getting hard to find and quite pricey for one, so I'll sell them both for

I also have another pair of two ton five stud axles, but I don't know what make they are.
However, the price for these is:$500.00 for the pair.

Hope this helps anyone looking to do an f600 4x4 build.



1 - 1 of 1 Posts