BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter · #1 ·
Hey all, my 22R is getting a bit bagged and inneed of about $500 worth of parts :p anyways i found a rusted out piece of **** 2wd toy that I can get for $200, the engine is perfect I have never seen a beter running 22R and the tranny is a 5spd.

I was wondering if I went and got the truck can I just pull the engine & tranny out of my truck and drop in the new 22R & 5spd?

Basicly is the tranny going to fit the same as my old one did?
 

·
Registered
Joined
·
363 Posts
depending on your abilities and the which trannies they are, you **may** be able to switch the tailshaft and extension housing on the tranny to allow it to mate to the t-case.
otherwise the engine is basically a direct swap as slacker said. youll have to swap oil pans, heater pipes, etc. you may have to remove some emissions equip. off the 2wd too. id recomend keeping as much as possible off you old engine (alt. etc) to keep future part replacement as easy as possible.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top