BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Looking for some help on the right way to build my engine. It's a 4bolt main 350, bored .040 over, 10.5:1 aluminum pistons. That is the short block that I have. I want to build a potent off-road engine with a power range of around 1500-6000. any ideas on heads(I want it to run cool so should I use an open chamber head?) intake, good off-road carb(I've always liked Carters on my street car) ignition, etc. This is the first truck engine I've built, everything else has been for 1/4 mile. the engine is going in an 82 toyota 4x4 with a th350, 203 t-case, and 4:10 toyota diffs with a spool in the rear. Thanks in advance, Wade

------------------
if it ain't broke, you don't go hard enough!
 

·
Registered
Joined
·
11 Posts
use a 194 head with a serp duaion cam a iksy 264/270 for in the range you want open chamber from a freind.
383 storker 400 trans 4;56 38s 77 jimmy
 

·
Registered
Joined
·
83 Posts
Discussion Starter · #4 ·
Thanks for the info Lloyd. That's about what I thought. Wade

------------------
if it ain't broke, you don't go hard enough!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top