BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
those are rarer than finding a high pinion dana 60 front!!!...good luck!

one suggestion for you is cutting down a fullsize box to fit if you or someone you know is a good welder...i have seen this done a couple times now...until the guy told me it was cut down i couldn't tell the difference, hoep this helps a little..:)

------------------
77 f250 460 4 spd, 60's f&r, 38 swampers<br>
ford message board-check it out
 

·
Registered
Joined
·
1,271 Posts
At least with the Ford you only need to shorten from one end. The axle-to-bumper dimension is the same on short or long box.

------------------
Current shopping list:
5.13 gears for RC Dana 44
3.90/3.92 gears for Dana 44
4 & 6 cylinder diesel engines
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top