BC 4x4 Forums banner
1 - 1 of 1 Posts

234 Posts
Discussion Starter · #1 ·
Hey Guys. In the middle of doing a shackle flip on the bronco, and am ready to bolt in my new hangers. A few of the tutorials I've read suggest pulling the gas tank, and maybe the rear bumper to get the bolts in, and they suggest welding them in place. I was thinking wouldn't it make more sense to weld 2 nuts together either horizontally or vertically to lock them to each other similar to how the OEM front sway bar bolts are done, allowing for tightening, and still the ability to remove the bolts later without cutting welds. Wondering if anyone else has employed this method?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.