BC 4x4 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
302 Posts
Discussion Starter · #1 ·
so has any one worked on an amc 20 rear before?i believe i just blew my pinion gear so is this a complicated job or something that is terribly hard?does anyone know of a website where it gets into a lot of detail.i pulled my cover as i noticed that it had a hole blew in it from chunks of my pinion getting thrown around.i am a bit scared to just start taking it apart i have hand tools and a little vehicle smarts but this i think is pushing it any help is appreciated!:welder :beer
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top