BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
I have body lift for a tj. The body kit is incomplete though.
I just have the spacers, and I just purchased new bolts. I know that I have to lower my radiator, and lengthen my shifter.
Is it possible to make the lower brackets for the raditor and is there a way to lengthen the shifter?
 

·
Registered
Joined
·
64 Posts
do you have a auto or standered?? and the rad brackets well need to lower the rad as much as you lift the body(body up 2 in rad down 2 in) for the tj their is also a streeing rod bracket that goes under the stedy bearing on the steering shaft and i think it is only 1/2 the lift hite and you will need to extend the gas filler line to the tank and their is another bracket that attaches to the t-case ****er and when i rememder what that looks like i will let you know :******* :*******
 

·
Registered
Joined
·
1,546 Posts
The rad mounts are just strips of 3/16 steel with two holes in them 2" apart.

To lengthen the 5 spd shifter you cut it, sleeve and extend it with a piece of steel, and weld it together.

To extend the gas filler you cut the rubber filler tube, insert a sleeve (any chunk of tube non -rusting and gas safe) and clamp it together 2" longer.

Can't remember what the steering bracket looks like.
 
1 - 3 of 3 Posts
Top