BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
the spacer you need for the 5.13 that you buy at breeze..
what happens if you dont have it? also.. does breeze have a website?
AND...
any one got a crown gear from a 5.13 they want to part with?


------------------
SPOA Samurai, 31's, stock engine, stock gears, and stock rust.
 

·
Registered
Joined
·
226 Posts
There web site is www.breezeindustries.com

The spacer goes under the ring gear. The reason it is there is so the side bearings will stay adjusted in the middle. The tube is there so the pins don't fall out. I have seen it done without it but I would drop the money on the kit. It makes the gear swap job done right.

HTH

------------------
87 Samurai, 92 fuel injected 1.6 ltr.,s.o.a., 5.13 r/p, birfield rings, 2" exhaust, 32/11.5 mud kings, breeze steering and missing links, 5012 up front with custom towers, toyota mr-2 seats, breeze trac bar, custom rock sliders and still going.

Click here to make money for listening to music !!
 

·
Registered
Joined
·
68 Posts
Discussion Starter · #4 ·
uhmm..i put the gears in.. and the sleeve.. but i dont know about the spacer.. yet everything sems to run fine.. so it seems..

------------------
SPOA Samurai, 31's, stock engine, stock gears, and stock rust.
 
1 - 4 of 4 Posts
Top