BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
302 Posts
Discussion Starter · #1 ·
How do ya remove the "push on" slip yoke seals on a standard type driveshaft? do you have to remove the grease nipple first?
 

·
Registered
Joined
·
2,324 Posts
The "push on" slip yoke seal you are talking about is actually threaded onto the drive shaft slip housing! Turn it counterclock wise to remove, you will want to remove the grease nipple any ways to ensure that it is clear of debris!

------------------
78 Bronco 351M NP435 NP205, D44 and Ford 9", and all stock!!!
 

·
Registered
Joined
·
302 Posts
Discussion Starter · #3 ·
NOPE my 81 driveshaft was threaded but my 84 driveshaft is actually a push on seal. switched to this style cause I was unable to get a threaded seal for my old shaft ... any way thanks for the reply, got it figured out tho
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top