BC 4x4 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
234 Posts
Discussion Starter · #1 ·
Link below show a great tool to use for butt welding panels. My question now is if I butt weld a new panel into a hole, after I finishing welding\hammering it, I guess I grind the weld down just a hair below the surface, then fill it, sand it, etc?

http://www.funinbc.com/forum/showthread.php?t=103903
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top