BC 4x4 Forums banner
1 - 2 of 2 Posts

·
Superfly
Joined
·
8,221 Posts
Originally posted by 4Low:
will the front and rear of the 4cyl yj w/ 4.10 gears work on a XJ? direct bolt on?
Neither end will be bolt-on. The Cherokee is spring-over-axle in the rear. Also, the perch locations are slightly wider apart anyway. And finally, the shock mounts will need to be re-positioned on the axle tubes.

On the front, if you are asking if it'll fit, then you definitely don't have the skills to make it fit. ;-) It's a lot of work because you'll need to either fabricate, buy, or transfer the control arm bracketry to the YJ front axle and make sure you get the geometry right.

...lars



------------------
19911995409993004:144444.103512.58274



 

·
Superfly
Joined
·
8,221 Posts
Originally posted by ScottH:
but i do believe the internals are interchangable?
Yes, I believe so. Oh, wait a minute...I can't remember if they both use high pinion Dana 30s. I've forgotten...I know all YJs had high pinion D30's. Early Cherokees should also have them. Not sure about the later ones. In any case, if you swap the internals, you'll have to get the gears set up.

...lars

------------------
19911995409993004:144444.103512.58274



 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top