Joined
·
145 Posts
I need a dana 44 pass side high steer arm asap! both sides would be nice to if the pass side can assept the tierod as well but i will settle for just about anything right now.
dana 44 high steer arm
1 - 7 of 7 Posts
Joined
·
608 Posts
I have a diff I may be parting out soon Its in the chev for sale section.
Joined
·
1,402 Posts
i have some pm me if you want?
Joined
·
145 Posts
im looking for the pass side mainly but also the drivers side if the pas side has 2 holes. want to do high steer with x over (not the inverted t style) let me know what u got. pics are nice too. also if they are steel or alum.
Joined
·
393 Posts
i have plate burns right now... passenger 1 or 2 holes... same with driver....
i even have plate burns with 1 or 2 holes forward with 1 hole back... either side... this is for hydro-assist or putting your tie-rod behind the axle
i can send pics of the plate burns if you wish but prefer not to cut them until they are bought.. cutting can be done within a week... depending what is going thru the shop at the time...
the 10deg angle is put on to... so they are not 'flat' flat... just not raised...
i even have plate burns with 1 or 2 holes forward with 1 hole back... either side... this is for hydro-assist or putting your tie-rod behind the axle
i can send pics of the plate burns if you wish but prefer not to cut them until they are bought.. cutting can be done within a week... depending what is going thru the shop at the time...
the 10deg angle is put on to... so they are not 'flat' flat... just not raised...
1 - 7 of 7 Posts
