[Vanilla Gorilla]

A future project I was considering to build is a Ford Bronco 2 and i would like to put a 300 (4.9l) I-6 engine in it. Dose any body have any ideas on this swap and what kind of modifications it might require. Any suggestions would be greatly appreciated. Thanks

 

[chevrolet]

i wouldnt recommend putting a ford 300 in it, a couple work trucks at my work have em and they burn as much or more gas than the 5.4s and less power

 

[Vanilla Gorilla]

bummer, at least with it bean a straight 6 it has allot of torq. Actually the 4.9l had all most double the torq then most 5.0l of its time. Thanks for the suggestion tho. :beer_cheers:

 

[HndMeDnBroncoII]

the 4.0L is the usual way to go.Also a a 2"body lift is very handy if you go up to the 5.0L im not sure about the 300 though.
the heater box on the right side usually gets in the way.
most of the stuff from explorers 94 and down and rangers 92 and down bolt up fairly easily.check out the ranger station .com
good luck any questions im here