BC 4x4 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
will the spindles,rotors,calipers etc. from an 81 chev 3/4 fit onto a 79 Ford D44? will i have to use the outer axleshafts too?

------------------
79 Bronco,no tires, 4"coils & re drilled mounts,shackle reversal soon to get D60/4.11 & matching gears for front
 

·
Registered
Joined
·
41 Posts
you will need the chevy knuckles for those spindles to bolt to, and youre ford axle shafts are just fine

------------------
White 88 Ford F 150, Long box, 96 Front clip,Carburated and Points ignition 302 Solid axle Front, 14`` Suspension lift, 39.5 Swampers, 1179 RTI------ UNDER CONSTRUCTION 86 Ranger Extcab, 351 v8 9`` Rear (full width)Dana 44 front(full width) Spooled front and rear, 4 corners on coils, undetermined lift height, Will roll on 35x16 Boggers
 
1 - 2 of 2 Posts
Top