BC 4x4 Forums banner
1 - 1 of 1 Posts

453 Posts
Discussion Starter · #1 ·
I was planning on lifting my blazer 4 in, but then i seen a blazer with a 6in susp and 3in body on 35's and i really like the look?? what about drive shaft with six inch, is there any possible way around drive shaft lengthening?? can i swap a rear shaft onto the front?? or something along thoses lines??

1985 K5 Blazer Fully Stock even gay 235r15 tires. On the way 4in susp 3in body 35's extensive engine build up and new camo paint
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.