BC 4x4 Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,437 Posts
Discussion Starter · #1 ·
Lookin for the length of the pitman arm on a D44 equipt Ford.
Center of hole to center of hole. Thanx.
 

·
Registered
Joined
·
1,437 Posts
Discussion Starter · #2 ·
28 views, and no ones willin to take a tape under thier truck???
Come Awn..... don't make me cruise the shopping malls (I hate gettin' caught under another guys truck):(
 

·
Registered
Joined
·
1,437 Posts
Discussion Starter · #4 ·
Just wondering how long it is. Wandering how much difference there is between my Ranger/BII pitman arm and the full size pitman arm.
 

·
Registered
Joined
·
4 Posts
my stock one is 5 7/8" inches from center of the hole to center ofthehole, i can give you that one if you think it will work. i don't need it any more.
 

·
Registered
Joined
·
1,437 Posts
Discussion Starter · #7 ·
Lookin for one measuring approx. 6 1/2 or better to keep my steering proportional.
Lil far to go for a pitman arm Bill, but thanx anyways.
Where are you located Badass??
 

·
Registered
Joined
·
2,324 Posts
6-5/8" measured perpendicular to the steering box shaft to the TRE bore.

78 Bronco
 

·
Registered
Joined
·
1,437 Posts
Discussion Starter · #9 ·
Can I get a spline count for the pitman arm?? Mines 32 spline (four flat spots). And a measure from top & bottom of the spline bore.

Or if anyones willing to part with one of these jems, let me know.
Thanx.
 
1 - 9 of 9 Posts
Top