BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
I just got my toy axels for my sammie but the problem is I want at least 10 inches of lift
and I was told that sammie drive shafts won't be able to stand up to that much lift it would not have enough opperating range.
So I want to switch to toy ones I know you can take the front drive shaft off a toy and put it on the back of my sammie but what do I do for the front.
Second what do I do about a toy t case should I swap for more options later or and go toy now or should I stay with a suzuki and just go 4:1
I will be running a VW 1.6td and will have to use a suzuki tranny so can I attach a suzuki tranny to a toy t case. I also need to know what mods have to be done if I change to a toy t case
WHAT SHOULD I DO HELP!!!!
Thanx Chubby
 

·
Registered
Joined
·
412 Posts
hey chubby try: island4x4.com in the "tech section" of the Message Board, (about 9 or so posts from the top)
"Zuki driveshaft solutions?" by TimJ- there are a couple replies by "BigFrank". you might find some of these usefull, or at least ask the dude more specific questions as to what he did. good luck.
 

·
Registered
Joined
·
392 Posts
Id recommend doing ur axles first, engine later but i have to ask........any reason you NEED 10" of lift or is this just to satisfy your ego ? You might be biting off more than u can chew here, you only have an 80" wheelbase, think about it.
 
1 - 3 of 3 Posts
Top