BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,889 Posts
Discussion Starter · #1 ·
Does anyone know where I can get a 4”–5” long and ½” thick good quality quick release pin. I went to Canadian Tire last night and found some in a hitch section, however they did not have straight ones, only the ones that are bent at about 45degree angle, and the straight section was only about 3.5” long. The locking pin didn’t look to be very secure.
I need it for my front radius arm purpose, so I don’t want to take a chance with something crappy!




------------------
If you didn't roll it, you havn't tried hard enough! I have...
 

·
Registered
Joined
·
1,889 Posts
Discussion Starter · #3 ·
I guess that could work...


------------------
If you didn't roll it, you havn't tried hard enough! I have...
 

·
Registered
Joined
·
1,437 Posts
Lordco. 5/8" shaft, 3 3/4ish long(before pin), red handle. Cut shaft to length you need, redrill hole. handle is a lil big but it makes it real easy to remove/replace pin. Cost 5 or 6 bucks.


------------------
BroncoIII
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top