BC 4x4 Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
475 Posts
Discussion Starter · #1 ·
my r150 had a coupler thing for the adapeter for dual gear driven cases, to get it off i had to remove the rear or the transmission to pound it out from the inside,

when i removed it a steel ball bearing- i think (1/4") fell out, does anyone know where it goes? tried to seach the net but no luck. thanks... brett
 

·
Registered
Joined
·
730 Posts
its a detent ball, if you look on the side of the transmission housing you pulled, you will see an allen head plug. remove it, pull the spring out. then put the housing back on the trans. this takes some finesse to do without knocking the shift rails out of wack. then reinstall the ball, then the spring, then the plug.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top