BC 4x4 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
1993 mazda 2600I 220km on the body and frame rust free
i am going to try and sell this as a hole and after a couple months if there is no interest i will part it out

the truck has no engine or transmission i have 2 toyota t-cases to go with it alone with all the parts required to put a 4.3 in it (motor mounts and all adaptors to a w56). i did have it running at one time for 700 km before the engine spun a bearing. the engine was a throw away so i will list what i have to go with it

*new rad for a 94 s10 with dual 11 inch flexalight fans with thermostat and controller
*power master stater, new flywheel and centerforce clutch (DF)
*custom CIA, msd 6al-2 and coil and wires
*optima batterie and new alternator
*fuel cell (19gallons) in the drybox with a walbro high pressure pump
*painless wiring harness for a vortec cpi 4.3

so i did all the work myself (certified welder). sas and rear 4 link (dual tri.)part in suspension

*trail gear hd 5.5 inch lift spring in the front
*bbcs 15 inch travel front shocks
*toyota ifs box land cruiser arm
*16 inch 2.0 nitrogen shocks from sway a way along with a regulator and hose to charge them
*currie flex joints in the rear upper links at 1.5 inch 3/8 wall lowers are 2 inch 1/2 wall
*the frame is beefed up to handle all the stress

the axles i spared nothing on theese and there is only 700km on both

*front LP 44 all rebuilt 4.45 gears ox locker, yukon chromos and super joints
*reverse highsteer(tierod behind axle) 1 ton chev tierod ends DOM tube
*rear is a 12bolt with moser eng 35 spline 1.5 inch shafts no c-clips and full spool
*rear has 12 inch disk brakes (no ebrake)

i am sure i am missing something other random things

*apc racing seats
*no name 9000 winch never used
*39.5x13.5x17 irocs x5
*17inch AR teflon wheels x5
*37 inch bfg km2 spare
*extra bearing rotor and hub are the spare mount
*explorer master cyl
*led taillight
*new 2.5 inch exhaust with flowmaster muffler
*alot of spare parts

9000$
i know i am asking high, i have put alot of time energy and money into it i would like to see someone have fun with it. will deliver anywhere in bc or alberta.
[email protected]
(250)640-2104





 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top