BC 4x4 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
i just installed a 3" body lift and the transfer case will not go into 4 low. 2 hi and 4 hi are ok but no 4 low. i know i could cut the body up as well as the console but i want to get away from doing that. does anybody have any ideas for me to bend or move the shifter over? this is all that i need to do then i am out wheelin again.
thanks for any advise

------------------
Trucks are built, not bought. When there bulit, beat em, break em and build em again BETTER!!
 

·
Registered
Joined
·
87 Posts
I did the same lift and I ended up cutting the body and the flange that holds the rubber shifter boot but I did not have to cut the console.
 
1 - 2 of 2 Posts
Top