BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
anyone have any sug ??? the holes that hold my skid plate onto my frame on my yj are striped i have one bolt left on the drivers side holding up that side and all are ok on the pass side im worried my tranny is going to drop any sug other than drilling through my frame or tappin the holes out bigger??????:violin
 

·
Registered
Joined
·
920 Posts
i had to do exactly that to mine, i just drilled out the studs that were left and put in really large lag bolts without even tapping it out first... not the best plan by any means but it was a quick fix, plan to go back and tap it out this week with some real bolts
 

·
Registered
Joined
·
112 Posts
What about running a square u-bolt (like a Toyota rear axle one ...) over the frame and down through the skid plate (you would obviously need to drill a couple of holes in the skid...)
It's the only No-welding solution I can think of
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top