BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,150 Posts
Discussion Starter · #1 ·
Dos anyone know who sells all the smaller items besides the plate that are needed to swap an SM420 into a 2F powered FJ40?
I need the special pilot bearing, indexing ring for the tranny to bellhousing and a sleeve that will allow the cruiser release bearing to be used on the SM420 input shaft.
I know I need a 3-speed bellhousing and an 11 inch chevy clutch disc.Do I have to grind the disc to fit it?
I am going to use the Extreme Bends plate.
Anyone who has done this swap can feel free
to post any tips.
Thanks.


------------------
75 FJ40, 4 inch BDS springs,1inch body, 35's, detroit locker, power steering, disc brakes, 3spd low range gears, full cage, XD9000i, extended shackles, dual batteries....you get the idea.
 

·
Premium Member
Joined
·
1,275 Posts
Hey Dp id talk directly to Steve from extreme bends. He can answer any of your questions

------------------
jeeps are for girls...
....cute ones!!
79 FJ cocked,locked and ready to unload!!!
 

·
Registered
Joined
·
1,150 Posts
Discussion Starter · #3 ·
Thanks Dan, he really has a lot of info on his site.

------------------
75 FJ40, 4 inch BDS springs,1inch body, 35's, detroit locker, power steering, disc brakes, 3spd low range gears, full cage, XD9000i, extended shackles, dual batteries....you get the idea.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top