BC 4x4 Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter · #1 ·
10:1 comp.030 pistons w/rings and rods assembled for 302.
Comp Cams 512lift 280duration.
20miles on the above then pulled the motor.
new remanufactured starter.

------------------
93bronco
 

·
Registered
Joined
·
155 Posts
Discussion Starter · #3 ·
Damn cat screwed the cam! I had it standing up in the carport and the cat knocked it over brushing it's ass against it.I'm pissed!
Pistons,starter,block030 over allreadyif you want it,gear to gear timing set,crank.basically whole bottom end minus the oil pump.$250

------------------
93bronco
 

·
Registered
Joined
·
2,324 Posts
hey, isn't there two bolt holes in the end of the cam, you should have hung the cam instead just asking the cat to knock it over, you pulled a HOMER! I am just giving you a hard time, can it be re-ground?

------------------
78 Bronco 351M SM435 NP205, D44 and Ford 9", and all stock!!!
 

·
Registered
Joined
·
155 Posts
Discussion Starter · #6 ·
I think it's bad,right on the tip of the lobe,looks nasty to me anyway.The culprit was the neighbors cat.I told the wife I was going to leave some antifreeze out about six months ago and she talked me out of it.I geuss I'll be making my neighbor drink it now.

------------------
93bronco
 
1 - 8 of 8 Posts
Top