BC 4x4 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
302 Posts
AFAIK the only difference would be the interiors and the rad support between the two body generations (80-86 and 87-89) either way the cab mountings remained the same throughout the pre 96 production ... if you look at the floor of the 2wd cab around where the floor shifter would be (you didn't say if it was auto or man) there will be a rectangular area that can be cut out and it is dimpled where you are to drill holes for the cover plate (you can use the plate from the beat up truck) OOPS just noticed it ext cab ... I'm not sure you will have to measure but I THINK the ext cabs had two extra mounts for the cab (I can check) Worst case you'll have to punch the rivets out (air chisel works great) and add them to the 89 frame (again there should already be holes in the frame for this) ... I'll get back on this.
 
1 - 1 of 1 Posts
Top