BC 4x4 Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
i have an 86 toyota pickup, trying to put 2 inch round led turn signal and combination brake and tail, cant seem to figure out how to make it all work

any suggestions
 

·
Registered
Joined
·
944 Posts
Obvious question, but does the light have three pins on the back?
 

·
Registered
Joined
·
944 Posts
Ya Ryno beat me to it, ask for stop, turn, tail lights. They have two circuits in them. One for tail, one for stop lamp or turn signal. Wiring in the trailer light adapter will combine the brake and turn circuits.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #10 ·
i think i found a light that will work, its oval shaped instead of round, and it has three wires coming out of it, but im gonna run a seperate signal
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #12 ·
yea the problem was the piece of metal on the bumper im using is only 4" total so they wouldnt fit, i found some oval lights that worked, but for some reason my tail lights dont work anymore, ive tried three different styles of lights and the tail lights dont work on any of them, fuses are good and wiring is good, not sure what the problem is..
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top