BC 4x4 Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 ·
are they any good or should I stick with stock replacement 8.0 wires? I have a 85runner.

------------------
85 SR5 4 runner, 7"sup,2" body, 35"BFG muds,5:29, wide track rear, vented rotor conversion, and no place to go.
 

·
Registered
Joined
·
193 Posts
I guess it depends. You will never notice a difference in horsepower or fuel economy when comparing new 8.0 wires and new 8.8 wires. Some people just like to run the best no matter what.

I guess maybe if you do a dyno you might see like...a 1/4 hp gain?
 

·
Registered
Joined
·
133 Posts
Discussion Starter · #4 ·
Thanks I`ll go pick them up just replaced the bad ones I had but need to get a good set so they are not miss-matched

------------------
85 SR5 4 runner, 7"sup,2" body, 35"BFG muds,5:29, wide track rear, vented rotor conversion, and no place to go.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top