BC 4x4 Forums banner
1 - 1 of 1 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
I'm swapping out the pinion flange (I think that's what it's called) from one rear third member to another due to mine having the larger bolt pattern, It's the flange that bolts to the rear drive shaft. Does anyone know what the torque spec is on the nut that holds it in place.?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.