BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Im putting them in my LJ had to move the spring spring hangers 4" out on each side, i wouldnt reccomend moving the spring pertch over the diff, then you'd need a really high pertch on the drivers side and that wouldnt be good, axle wrap would eat your springs alive! and i think its just a really bad idea


HTH

Beer

------------------
I live for SCORT.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
So did you use the stock Toy spring location? Rear? Toy springs? Stock running gear?

I think I am going to use a u-bolt on the outer and thread the bottom plate on the inside....(Have seen this done) I have added a leaf to all 4 so they are a bit stiffer but still flex very well. I might add another leaf to fit 35" Boggers.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top