BC 4x4 Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
100 Posts
I would believe it is!!
If this motor combanation was any longer it wouldn't be practical too do.


------------------
A real 4by is one that has been over on all four sides.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #5 ·
that is not the same engine i am puting in mine, i am using a 1.6 corolla hemi engine
pushrod engine hopfuly smaller than that
but the trans is pretty long, how far back did you have to move the t-case?
 

·
Registered
Joined
·
100 Posts
yup I realize your skinning another cat but there may be something usefull to get out of the pix.
We moved the T-case about 5 inches back
and will connect it together with a toy universal and a rubber coupler from a mercedes.
you can find more pix here http://island4x4.com/cgi-bin/yabb/YaBB.cgi?board=moose
We are using a stock rear d-shaft in the front and a shortened rear in the rear.
the tunnel spot welds must be popped and the leftside moved 1cm on the side/center and the right side moved 1 inch along the side and 2 inches at the front to clear the clutch and starter. We are also giving a 1" body lift.

------------------
A real 4by is one that has been over on all four sides.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #7 ·
what are the measurements on the 22r, how long with the tranny on it, hoping minw is smallar or else it may not be a weekend prodject
 
1 - 8 of 8 Posts
Top