Joined
·
1,335 Posts
Joe 604-808-0521
Two core rad about a year old. No leaks comes with pretty new hoses. $50
G52 tranny $50
![]()
Good solid starter $25 x2
Its coming out tomorrow would like to get it out the door fully dressed. 22re with a crawler cam, newish alternator, throttle body, engine harness. Rear main seal was done about a year ago when the clutch was done. Clutch is about a year old on it too. Oilpan and front pully seal leak. I have a bunch of extra seals I can send along with it. Was running when I had it but I would clean it up and do a once over on it, replace seals, check the bearings on the bottom end etc. Ran strong when I had it. $400
![]()
22re OBA setup. York compressor, tank...everything you need except the dash switch to turn it on. You should get a hydro line made up to go off the compressor to the manifold. I had lines made up by a friend but I haven't tried to put them on. I think they might be too big but you can take them too and probably just buy an adapter. $400
Two core rad about a year old. No leaks comes with pretty new hoses. $50
G52 tranny $50
Good solid starter $25 x2
Its coming out tomorrow would like to get it out the door fully dressed. 22re with a crawler cam, newish alternator, throttle body, engine harness. Rear main seal was done about a year ago when the clutch was done. Clutch is about a year old on it too. Oilpan and front pully seal leak. I have a bunch of extra seals I can send along with it. Was running when I had it but I would clean it up and do a once over on it, replace seals, check the bearings on the bottom end etc. Ran strong when I had it. $400
22re OBA setup. York compressor, tank...everything you need except the dash switch to turn it on. You should get a hydro line made up to go off the compressor to the manifold. I had lines made up by a friend but I haven't tried to put them on. I think they might be too big but you can take them too and probably just buy an adapter. $400
