BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #2 ·
I need it measured from the bell housing to the rear output flange on the t-case. Yep I want to swap them in and adapt the samy t-case so i can run dual transfer cases.I just want to see how much room i have too work with. I know theres not much but it can be done...


Originally posted by kicker_92:
What do you nead measured? I'll probably be under my rig soemtime this weekend so could check for ya.

What are you planning on doing, swap both then adapt the sami case to the output?

Ryan Gates
92 Sidekick


------------------
Custom $12 Camo paint job
http://www.coastcustoms.com
 
G

·
Are you going to index the t-case on the tracker so you can still run a front shaft on the sammy t-case?Being 1:1 in high range would be a bonus with the different ratio rear case.I know with the lj80 or a sammy case paired together high range is a bit of a joke.

------------------
If it's too deep go faster
 

·
Registered
Joined
·
401 Posts
Jay,

sorry I didn't get back to you last night. I will measure it up tonight and take some digi pics (its a little grimy still
)

THe rear and front outputs are slip yoke just so you know. I will throw in the slip yoke portion of the driveshafts but the shafts themselves I'm keeping.

I will email ya privately tonight

------------------
IRC member
1986 radio flyer, red
 
1 - 4 of 4 Posts
Top