BC 4x4 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 95 YJ with a stock suspension. Over the last few months it has developed a leak at the transfer case output seal. The leak fairly minor and does not seem to be
getting worse.

How much leaking, if any, is acceptable?
Is there anything I can do to keep it from getting worse?

Thanks
 

·
Registered
Joined
·
2,962 Posts
The design of the seal is that it must "leak" to work. They all wear a little bit after a while and leak a little more, but it is generally very slow.

Fix it by repacing the seal.

Wes

------------------
...a member of the herd
www.hot.alloffroad.com
 

·
Registered
Joined
·
2,513 Posts
New seals are typically under $10. If you're careful you could probably replace it in about 15-20 min.

Of course you could mangle the seal if you don't put it in straight. A block of wood and some careful hammer work will do the trick.

------------------
Jon B.
'82 CJ7 Some mods.
 
1 - 4 of 4 Posts
Top