BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
I am about to redo the front end on my Bronco and I was wondering what the crossover gear size is for the carrier. I would like to keep the carrier if possible as it is a limited slip.

------------------
77 F250 w/35 BFG MT[gone to a better place
]
88 Bronco Eddie Bauer w31 Big O MT's( under construction
to do some good wheeling)

[This message has been edited by kenny (edited February 04, 2002).]
 

·
Registered
Joined
·
195 Posts
Hey Tracy

I had to get a new carrier when I went from 3.54 to 4.09...

------------------
James King
95 F150 4"lift on 33's..
4.10's Auburn Posi
3" no cats exhaust...MSD
1981 F250 4x4 351M stock for now
Surrey B.C.
 

·
Registered
Joined
·
302 Posts
check your other post ... the carrier split is standard D44 (the TTB44 is just a Rev cut D44 without tubes and a little extra cast iron) the carrier split is 3.73 down and 3.92 up.

------------------
81 Bronco 33s
92 YJ 31s
84 Bronchial spasm
 
1 - 3 of 3 Posts
Top