BC 4x4 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
where can i get parts and or information on twin sticking a dana 20.

what exactly does it do?

ive heard both that it can be front and rear each on a stick, or else it can be on lever h or low, and one lever 2 and 4

thanks all.

my commando is comming apart, and slowly looking better, i think.

also if i swap the i6 out for the 360, will it bolt up to the turbo 400 in the commando, or do i have to get another flywheel for the tranny

ive been told that the 6 and 8 are balanced differently, and that i will need a flywheel from a turbo400 that bolted to a 360 to work. is this true.

My appologies if someone here already answered this, as ive lost all my old emails, and cant remeber who said what and why. I do know that a standard transmission parts dont interchange, but i think the auto should
 

·
Got Arbutus?
Joined
·
1,269 Posts
for the twin stick info check out my np435-d20 write-up in the wrenching section on the front page. it has some good info in it that will make your life a little easier during the project.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top