BC 4x4 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter · #1 ·
Hey guys, I have just acquired a FJ 80 rear axle and want to get it centred to run two short side shafts. Anyone recommend a place to have this done?
 

·
Registered
Joined
·
179 Posts
Discussion Starter · #3 ·
Was hoping some one had good experiences outside of Vancouver. It's about an 8 hour drive for me and wanted to see if anyone else knew a good place. I did email BCC though and am awaiting. Curious to see what it might cost.
 
1 - 3 of 3 Posts
Top